The Auckland House Book
An owner's manual for Auckland houses, old and new

Reading a builder's pre-purchase report: the sections that matter

19 November 2026 · 5 min read

A pre-purchase building report arrives as a thick PDF full of photos, ratings and cautious wording, usually a day or two before your conditions expire. Most of it is routine. A handful of paragraphs decide whether you buy, renegotiate or walk away. Knowing which is which is mostly a matter of understanding what the report is, and what it is not.

Begin with the scope and limitations

The page most people skip is the one that matters most. Standard reports follow NZS 4306:2005, which is a visual inspection. Government consumer guidance spells out the limit: the inspector cannot see problems hidden behind finished surfaces, such as plumbing, framing, insulation or wiring, and the report is a set of clues rather than a guarantee (Consumer Protection NZ, building reports red flags).

Read this section for three things: which areas were inaccessible, which were not inspected at all, and who the client was. If the roof space or subfloor could not be entered, you do not have a clean bill of health for those areas; you have a gap. A report that the vendor paid for is also written for the vendor, which is why the same guidance recommends commissioning your own.

The summary table and what the ratings mean

Most reports open with a summary listing items as urgent, recommended or minor, or something similar. Do not take the colour coding at face value. Ask what each rating means in the inspector's own terms, and ask the inspector directly if a phrase is unclear. The guidance suggests that a reading is often inconclusive on its own; high moisture, for example, could mean serious rot or simply damp after rain.

That is why the follow-up question matters more than the label: what happens if this is left, and how soon does it need attention? An answer of "cosmetic, repaint within a few years" is a very different thing from "monitor for active movement" or "intrusive investigation recommended".

Moisture readings and weathertightness comments

For a house built from the late 1980s to the mid-2000s, the moisture section deserves the closest reading. Settled, the government's home-buying site, says plaster-style monolithic cladding is the main risk and recommends an independent inspector who uses a moisture meter and lists areas they could not check or that need further investigation (Settled, learning about leaky buildings).

Look for readings at windows, door joinery, balconies and the base of walls, and look at where the inspector recommends further testing. A report that says "elevated readings at the north-facing window, invasive testing recommended" is telling you something specific. A vague line about "general weathertightness" is not.

Findings that usually trigger a specialist

Certain items point beyond a general building inspector. The consumer guidance lists possible earthquake damage, natural hazard exposure such as flooding or slips, suspected leaky-home construction and uncertain boundaries as matters for specialists. Other findings often prompt a trade check: old wiring suggests an electrician, damaged or aged plumbing suggests a plumber, and timber pest damage suggests a specialist.

Borer is a good example of a finding that is easy to under-read. A line such as "evidence of borer in subfloor timbers" does not tell you whether it is active, how widespread it is or whether any timber is structurally compromised. If your report notes flight holes, the question that matters is is borer a deal breaker for this particular house, and the answer depends on activity, location and the load the affected timber carries rather than on the mere presence of holes.

Photos, notes and attending the inspection

Inspectors photograph problem areas, and the notes beside the photos often contain more detail than the summary. Look at the angle and distance of each image: can you tell what part of the house it shows? Cross-reference the photos with your own viewing, particularly for anything near the roofline, under floors and around wet areas.

The guidance also notes that attending the inspection lets you see issues first hand, although it may cost more or take longer. Even if you cannot be there for the whole visit, arranging a short walk-through with the inspector at the end is often the quickest way to learn which items worry them most.

Matching the report to the paperwork

The inspection will not tell you whether alterations had building consent. That is the job of the council property file and the LIM, which should be read alongside the report. If the inspector notes a deck, a converted garage, a moved toilet or a new room, check whether the file records consent. Unconsented work can be difficult and expensive to regularise after the event, and it can affect insurance and resale.

If the vendor supplied a report, treat it as background only. Where it is accompanied by a LIM, ask your lawyer to review both and to confirm that the LIM covers what you need to know.

Turning the report into numbers

Once you have identified the items of concern, ask a builder or relevant tradesperson to price them. Consumer Protection suggests using those figures to decide what you will fix yourself, what you might ask the vendor to address as a condition of the offer, or whether to withdraw. Where the cost is uncertain, build in a condition for further investigation rather than guessing.

For concerns about timber pests in particular, Lignum Timber Inspections publishes material on how borer findings are assessed, which is useful background to read before you speak to an inspector or negotiate with a vendor.

Sources

Keep reading