The Auckland House Book
An owner's manual for Auckland houses, old and new

Subfloor checks for older Auckland houses

19 November 2026 · 5 min read

The space under an older house is the part of the building most owners have never seen. It is dark, cramped and a little unpleasant, which is exactly why problems there can run for decades. It also does more work than it appears to: it carries the floor, keeps the framing dry and, in many villas and bungalows, is the first place moisture and borer show up. A short annual look is enough to catch most issues early.

Do it with a plan

Pick a dry day and wear overalls, gloves, a dust mask and a head torch. Check that the access hatch is clear, and tell someone you are going under. If you notice anything that looks like asbestos cement, damaged lagging or similar material, stop and get advice before you touch it. WorkSafe notes that intact asbestos is generally not an immediate hazard and that the danger arises when it is damaged or disturbed (WorkSafe, asbestos information for homeowners).

BRANZ recommends checking the subfloor space annually as part of normal house maintenance (BRANZ, subfloor ventilation).

Moisture first

Look at the ground. Is it damp, muddy or showing standing water? BRANZ offers a rough test: rub a little soil between your fingers, and if it stains like mud, there is probably too much moisture. Look for mould or condensation on timber, particleboard or foil insulation, which are further clues.

Ground moisture is a big part of why a subfloor behaves badly. The Natural Hazards Commission's maintenance guide lists a poorly ventilated subfloor, no ground moisture barrier and leaking plumbing among the causes of springy flooring (Natural Hazards Commission, looking after your home). For rentals, the healthy homes standards now require a ground moisture barrier where there is an enclosed subfloor (Tenancy Services, landlord guide), and the same measure helps owner-occupied houses. BRANZ says polythene ground cover can reduce subfloor moisture.

Ventilation and drainage

Walk the perimeter and check that every vent is clear. Soil and gardens built up against the house are a common cause of blocked vents and dampness, according to BRANZ. Stored timber and rubbish under the house can also stop air moving. The current acceptable solution for suspended timber floors specifies a minimum net opening area of 3,500 mm² per square metre of floor, and BRANZ surveys found most older houses fall short of that.

Then look at where the water goes. Downpipes should discharge into a gully trap or drain, not onto the ground beside the house. The Natural Hazards Commission warns that blocked downpipes or gully traps cause ponding that can soak the subsoil and undermine foundations.

Piles, bearers and joists

Piles are the next job. BRANZ suggests pushing a screwdriver into each pile just below ground level; rotten timber gives easily. Rotten piles generally need replacing with H5 treated timber or precast concrete, which is work for a builder. Check that piles are upright, that each bears properly on the bearer above, and that bracing is present.

Run your torch along bearers and joists, looking at the ends and at any point where timber meets masonry or soil. BRANZ's 2015 house condition survey found many subfloors had corroded or missing fixings and inadequate bracing, so give metal fixings a look too. Floors that feel springy, noticeably sloped or squeaky above often match something visible below.

Borer and rot

Older houses were often built with untreated native timber, and borer thrives in damp wood. Look for small round holes in timber, usually a couple of millimetres across, and fine dust beneath them. Many of those holes are historic, and the difficulty is telling old from active. For flight holes in joists, bearers or sub-floor framing, the question of borer in floorboards and the timber under them is worth a specialist assessment, because the safe treatment and the need for structural repair depend on how far activity extends.

The Natural Hazards Commission notes that borer infestation can weaken the subfloor framing and show up as defects in the floor above. If a screwdriver sinks into a joist or a bearer, or you find soft, crumbling timber, treat it as rot and get it looked at promptly.

Plumbing, wiring and insulation

While you are down there, look at pipe runs for drips or staining, since leaking plumbing is one of the moisture sources the Natural Hazards Commission lists. Note any insulation hanging off the underside of the floor, and any wiring that is unsupported or lying on the ground; an electrician can judge cables that look old or brittle.

What to write down

Bring a notebook as well as a torch. Sketch the footprint of the house and mark the location of each pile, vent and access point, then note anything unusual against that sketch: a damp corner, a leaning pile, a vent blocked by garden soil, a patch of holes in a joist. A rough drawing is far more useful than memory when you are describing a problem to a builder, and it lets you see at a glance whether a trouble spot is the same one you noted last year.

When to call someone

A homeowner's visit is a screening step. A builder or a specialist is the right call for rotten piles, moved or sagging bearers, active borer, signs of a persistent leak, or anything that looks structural. A pest specialist such as Lignum Timber Inspections can assess timber pests and write up what is active and what is historic, which gives you a clear basis for deciding how much to spend.

Record what you find with photos, so next year's check has something to compare against. Floors rarely fail overnight; they drift, and a yearly record shows the drift.

Sources

Keep reading