Gutters, spouting and downpipes: maintenance basics
Gutters rarely get attention until they fail, and when they do the damage is quiet. Water pours over the edge and soaks the weatherboards, runs down behind the cladding or pools beside the piles. Most of the repair bills that follow could have been avoided with a ladder, a bucket and an hour or two. This guide covers what the system is for, how it goes wrong and how to inspect and look after it.
The job the system does
The Natural Hazards Commission describes gutters and downpipes as integral to a home's wellbeing because they divert rainwater away from the roof, walls and surrounding land (Natural Hazards Commission, looking after your home). Downpipes should direct water into a gully trap. When gutters, downpipes or traps block, water ponds, and the Commission says this can leave stale, dirty water under the house or soaking into the subsoil, potentially undermining foundations.
BRANZ makes a similar observation: damaged, sagging and blocked gutters and downpipes are often found, and are a common cause of excess moisture around foundations and of moisture re-entering the building (BRANZ, common maintenance issues).
How things go wrong
- Blockage. Leaves, twigs and moss build up and stop water reaching the downpipe. According to the Commission, clogged gutters can lead to leaky roofs and damage to interior linings.
- Poor fall. Gutters need to slope towards the outlet. Poorly levelled gutters overflow rather than discharge, according to guidance cited by NZ spouting firms.
- Sagging or loose brackets. Weight from debris and water pulls brackets out of the fascia. A gutter that has dropped at one end will hold water and overflow.
- Corrosion and holes. Older steel spouting rusts at joints and low points, and leaks at laps.
- Undersized spouting. If a gutter overflows during every heavy storm even when clean, it may be too small for the roof area. BRANZ has published guidance on gutter and downpipe sizing.
- Internal gutters. The Commission flags these as particularly problematic if not maintained, because a leak shows up inside the house.
Pests and the roof space
One reason to keep gutters clear is not obvious from the ground. The Commission notes that clogged gutters create comfortable environments for pests and rodents, which can lead to problems in the ceiling space, such as damage to electrical wiring. Rats and mice use overhanging trees to get onto roofs, according to Waitaki District Council (Waitaki District Council, rats and mice), so a roofline that is tidy and clear of branches is part of keeping them out.
How often to check
The Commission recommends regular cleaning of gutters and downpipes, and installing gutter guards where possible to reduce debris build-up. Insurers' guidance often suggests cleaning twice a year, with an extra check after heavy rain. In an Auckland house under mature trees, autumn leaf fall and the end of winter are sensible times. Houses beneath pÅhutukawa or other messy trees may need more frequent visits.
Doing the inspection safely
The Commission is blunt that cleaning gutters can be dangerous and that you should seek advice before working at heights or near electrical cables. Take that seriously. Use a ladder on firm ground, keep three points of contact, never overreach, and stay well away from the service line to the house. If the gutters are above a single storey, or the roof is steep, a professional is a better choice.
From the ground, you can do a lot with binoculars. Look for sagging runs, plants growing from the gutter, stained fascias and water marks on the walls beneath the eaves. Then do the same in the rain: watch where water runs when it pours.
Cleaning step by step
- Place a bucket or tarp to catch debris, and wear gloves.
- Scoop out leaves and sludge by hand or with a small trowel.
- Flush with a hose, starting at the end furthest from the outlet, and check that the water reaches the downpipe cleanly.
- If a downpipe is blocked, clear it from the top, or from the bottom if you can disconnect it.
- Check the gully trap and surrounding drain for debris.
- Look at joints, brackets and the fascia behind the gutter.
Keep debris out of stormwater drains, and dispose of it in the garden or green waste.
Where the water goes
A clean gutter can still send water to the wrong place. Check each downpipe discharge: it should lead into a gully trap or stormwater drain, with no ponding beside the house. If water collects near piles or against walls, the problem is lower down, and may be a blocked drain or ground that slopes towards the house.
For rentals, this matters for compliance too. The healthy homes standards require efficient drainage, guttering and downpipes, as well as a ground moisture barrier for enclosed subfloors (Tenancy Services, healthy homes compliance).
Repair or replace
Small problems have simple fixes. Reseal leaking joints with an appropriate sealant, refit loose brackets, and realign sagging sections. Replacement makes sense when metal is rusted through in several places, when the slope cannot be corrected, or when the capacity is not enough for the roof. BRANZ's roof drainage guidance recommends a minimum gutter width of 250 mm to allow for maintenance, and its internal-gutter bulletin notes that wider gutters are easier to clean and repair.
Gutter guards help in leafy sites but do not remove the need to look. Fine debris can still collect on top of or under them, so check them at least annually.
When overflow points to something else
If gutters overflow after cleaning, consider these in order:
- Is a downpipe or the drain below it blocked?
- Is the gutter level, with the right fall to the outlet?
- Has a roof alteration increased the area draining to one gutter?
- Is the spouting simply too small?
A roof plumber can answer the last two. Do not leave persistent overflow unresolved, because the damage it does to timber, paint and foundations is gradual and expensive.