The Auckland House Book
An owner's manual for Auckland houses, old and new

Moving into an older house: a first-month checklist

19 November 2026 · 5 min read

The first month in an older house is the cheapest time to learn how it behaves. Nothing has been moved in front of the wardrobe, you notice every draught, and the seller's paperwork is fresh in your inbox. The goal is not to fix everything. It is to find out which things are safety jobs, which are slow-burn moisture problems, and which can wait until you know the house better.

Work through the list below roughly in order. The early items are quick and cheap; the later ones tell you where to spend money.

Week one: safety and paperwork

Start with smoke alarms. Consumer NZ's buying guide says New Zealand law requires alarms in all residential buildings, on each level of a multi-level home, in every escape route such as a hallway, and within 3 m of each bedroom door or inside any room where someone sleeps. It also recommends photoelectric alarms, which Fire and Emergency New Zealand favours, and notes that ionisation alarms have been removed from sale. If an alarm in your new house has a radiation symbol on the casing, replace it. Sealed alarms with a built-in battery last about ten years; units with a replaceable 9V battery need a fresh battery every year. Hard-wired alarms must be fitted by a licensed electrician, and if you are planning a renovation, that is the cheapest moment to add them. Consumer NZ also notes that interconnected alarms, where one sounding triggers all the others, are now a legal requirement for new builds and in some cases for extensively renovated houses.

Next, collect the paperwork. If you bought with a LIM, read it again now that the house is yours. Auckland Council also sells a property file, which holds building and resource consent documents and correspondence that the LIM summarises. The council is clear that the file only includes work it knows about: if a previous owner built a deck or enclosed a porch without consent, it will not appear. Walk the house with the file in hand and note anything physical that has no matching paperwork. That list is useful if you later renovate or sell.

Find the water shut-off and the switchboard on day one, and label them. If anyone mentions leaks or tripping circuits, write down where.

Weeks one and two: look at moisture

Older Auckland houses are rarely failing because of one dramatic defect. More often it is a handful of small moisture paths. Healthify's guide to damp and mouldy homes gives a useful owner's checklist, and most of it can be done in an afternoon:

Then go under the house if you can. Tenancy Services' moisture standard for rentals is written for landlords, but it is a good benchmark for any owner: an enclosed subfloor should have a ground moisture barrier, generally a polythene sheet, and the property should have working drainage for roof and surface water. If the soil under your floor is bare and damp, that is a fix worth putting near the top of the list, because it also affects borer, which thrives in damp timber.

Weeks two and three: insulation and ventilation

Ceilings first. Guidance on building.govt.nz gives a rough rule of thumb: if existing ceiling insulation is thinner than about 120 mm, add more, and look for gaps in coverage. Keep a clearance around old downlights and electrical gear. Turn the power off before you go into the roof space, and call an electrician if you are unsure what you are looking at. If you find aluminium foil underfloor insulation, the same guidance says it is inadequate, can be a hazard near wiring, and should be replaced rather than repaired.

For fans, the rental standard again gives you a yardstick. New kitchen fans or rangehoods should have a duct diameter of at least 150 mm or move at least 50 litres per second, and new bathroom fans 120 mm or 25 litres per second. An old fan that rattles but vents outside is fine; one that discharges into the ceiling space is not.

Week four: look for pests

By now you will have been in the roof space, the subfloor and the garage. Write down what you saw: droppings, gnawed wiring, fine dust under timber, small brown beetles on windowsills. Small signs are easier to deal with early, and a short list makes any quote easier to compare. When you start asking for quotes, it helps to understand what drives pest control costs in Auckland: the pest involved, how big or difficult the property is, and whether follow-up visits are included.

What can wait

Cosmetic work, a new kitchen and the garden can all wait. So can wall insulation, which building.govt.nz notes is usually difficult to retrofit and typically needs building consent, so it is best planned for a time when linings or cladding are being replaced. Spend the first month finding out where the water goes and how the air moves; every later decision will be better for it. And if your notes include anything that needs professional eyes, Pest Control Auckland publishes a pricing page that sets out typical ranges by service and what is usually included, which is a reasonable thing to read before you pick up the phone.

Sources

Keep reading